Table of Contents
Advertisement
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.
Orientation
Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure that the structure onto which you are mounting the product can support the product's
weight. See the
Technical Specifications
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
When power linking multiple products, mount the products close enough for power linking cables to reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.
Procedure
The STRIKE Saber comes with a bracket to which a mounting clamp can be attached. A mounting clamp is
not included. Make sure the clamp is capable of supporting the weight of this product. Use at least one
mounting point per product. For the CHAUVET Professional line of mounting clamps, go to
www.trusst.com/products.
Floor Stand
The STRIKE Saber comes with a Floor Stand which can be installed to the bracket with the included
screws.
Mounting Diagram
Overhead Mounting
Safety Cables
Floor Stand Installation
Page 6 of 19
for weight information.
Insert included screws (x4)
http://
Mounting Clamp
Mounting
Bracket
Bracket
Adjustment Knobs
STRIKE Saber User Manual Rev. 1
Setup
Advertisement
Table of Contents
