Table of Contents
Advertisement
Main Level
LED
Frequency
Back Light
Fixture Hours
Information
Version
UID
Reset
Factory
Configuration (DMX)
Use control configurations to operate the product with a DMX controller.
Control Personalities
This setting allows you to choose a particular control personality.
1.
Go to the DMX Personality main level.
2.
Select the desired personality, from 3Ch, 5Ch, 6Ch, 8Ch, 9Ch, 21Ch, 27Ch or 43Ch.
•
See the
personality.
•
Make sure that the starting addresses on the various products do not overlap due to the
new personality setting.
Starting Address
Each product will respond to a unique starting address from the DMX controller. All products with the same
starting address will respond in unison.
1.
Go to the DMX Address main level.
2.
Select the starting address (001–510).
The highest recommended starting address for each DMX mode is as follows:
Page 8 of 19
Programming Levels
600Hz
1200Hz
2000Hz
4000Hz
6000Hz
25KHz
On
10S
20S
30S
<_ _ _ _H>
<V_._ _>
<_ _ _ _ _ _ _ _ _ _ _>
No
Yes
Starting Address
section for the highest starting address you can select for each
Personality
3Ch
5Ch
6Ch
8Ch
9Ch
21Ch
27Ch
43Ch
Description
Sets the PWM frequency
Display backlight always on
Turns off display backlight after 10 seconds
of inactivity
Turns off display backlight after 20 seconds
of inactivity
Turns off display backlight after 30 seconds
of inactivity
Shows total hours the product has been on
Shows current firmware version
Shows product UID
Resets the product to factory default settings
Address
510
508
507
505
504
492
486
470
STRIKE Saber User Manual Rev. 1
Operation
Advertisement
Table of Contents
