Table of Contents
Advertisement
PRELIMINARY SETTINGS ON THE TOOL
a. Automatic blade speed:
The density sensor (15) located at the front of the mower
automatically regulates the rotation speed of the cutting
blades, which will varies between 3000 and 5000 rpm
depending on the density and height of the grass.
For the mower to automatically adjusts the speed of the
cutting blades, you must set the mower to automatic; a
single green LED will light up.
When the optical sensor is soiled, it can no longer
analyse the density and the height of the grass to be cut.
The mower stops the rotation of the cutting blades and a
flashing error code is displayed on the control box.
Flashing error code of
the obstructed optical
sensor:
The optical sensor (15) must therefore be cleaned so
that the lawn mower can continue to automatically adjust
the turning speed of the cutting blades.
Turn off the battery.
Always clean the optical sensor with water and a wet
cloth then turn the battery back on .
Never use solvents!
If you still want to continue working, switch to manual
mode, select one of the three speeds and clean the
sensor later.
b. Manual blade speed:
You can also manage the turning speed of the cutting blades manually by configuring the lawn mower in
one of the 3 possible settings.
The thicker and higher the grass, the faster the turning speed of the blades should be.
15
15
19
Advertisement
Table of Contents
