Additional Information About Each Function; Default Values; Default Function Values - Siemens SIMATIC 505 Installation And Operation Manual

3.5

Additional Information about Each Function

Default Values

SIMATIC 505–2556 Installation and Operation Guide
There are default values for every function that is supported. If no data is
transferred to the module and the enable bits for a function are set and
written to the module, then the default values will be used. See Table 3-8.
NOTE: No matter what functions are enabled, the actual hardware data
from the I/O channel is always present in WX33 – WX48.
Table 3-8 Default Function Values
Functions Enabled
Alarm setpoints
Scaling engineering units
Offset mode 4–20 mA
Filtering time constants
Averaging
Peak hold
Valley hold
Table 3-9 Default Function Values for SIMATIC 505–2556
Functions Enabled
Alarm setpoints
Scaling engineering units
Filtering time constants
Averaging
Peak hold
Valley hold
Low Default Value
1000
0
6400
250 msec
20 averages
0
0
Low Default Value
50
0
250 msec
20 averages
0
0
Advanced Function Programming
High Default Value
31,000
32,000
32,000
0
0
High Default Value
200
100
0
0
3-19