Fuji Xerox DocuPrint 203A Quick Setup Manual page 5

QSG_Eng.book Page V Tuesday, April 26, 2005 11:03 AM
Be sure to switch off and unplug the machine
before accessing the interior of the machine for
cleaning, maintenance, or fault clearance. Access to
a live machine's interior can cause electric shocks.
When the machine is not used over an extended
period of time, switch it off and unplug it. If an
unused machine is left connected to a power source
for a long period, degraded insulation can cause
electric shocks, current leakages, or fire.
Once a month, unplug the machine and check
the power cord for the following:
- The power cord is plugged firmly into a receptacle.
- The plug is not excessively heated, rusted, or
bent.
- The plug and receptacle are free of dust.
- The cord is not cracked or frayed.
If you notice any unusual conditions, contact our
Customer Support Centre.
For machine operation
Do not place any liquid container such as a vase
or coffee cup on the machine. Spilt water can
cause a fire or shock hazard.
Do not place any metal parts such as staples or
clips on the machine. If metal and flammable
parts get into the machine, they can short-circuit
internal components, and cause fire or electric
shocks.
If debris (metal or liquid) gets into the machine,
switch off and unplug the machine. Contact our
Customer Support Centre. Operating a debris-
contaminated machine can cause fire or electric
shocks.
Never open or remove machine covers that are
secured with screws unless specifically
instructed in this guide. A high voltage component
can cause electric shocks.
Do not try to alter the machine configuration, or
modify any parts. An unauthorized modification
can cause smoke or fire.
Do not play this CD-ROM using an incompatible
CD-ROM player. Playing at high volume levels
can cause hearing damage and speaker failure.
This equipment is certified as a Class 1 laser
product under [IEC60825]. This means that the
machine does not emit hazardous laser radiation.
Since radiation emitted inside the machine is
completely confined within the protective housings
and external covers, the laser beam cannot escape
from the machine during any phase of user operation.
Do not perform any operation apart from the
instructions given in the manual. There may be a
danger of laser beam leakage.
Never touch a labelled area found on or near the
fuser unit. You can get burnt. If a sheet of paper
is wrapped around the heat roller, do not try to remove
it by yourself to avoid injuries or burns. Switch off the
machine immediately, and contact our Customer
Support Centre.
After you have just used the printer, some parts
inside the printer are extremely hot. When you
open the front cover or back cover of the printer,
never touch the shaded parts shown in the
illustrations. Wait for the printer to cool down before
you touch the internal parts of the printer.
Open the back cover
Inside the printer
(Front View)
Do not use conductive paper, e.g. folding paper,
carbonic paper and coated paper. When paper
jam occurs, they can cause a short circuit and fire.
The fuser unit is marked a caution label. Please
do not remove or damage the label.
For consumables
Never throw a toner cartridge into an open flame.
Toner remaining in the cartridge can cause an
explosion and you can get burnt.
Never use a vacuum cleaner when you clean
spilled toner. It can cause explosion as the toner
fills the vacuum cleaner and gets sparks. Use a
broom or a wet cloth.
Never heat the drum in a drum cartridge, or
scratch its surface. A heated or scratched drum
can be hazardous to your health.
Be careful not to inhale the toner.
If your clothes are smeared with toner, wipe off
the toner with a dry cloth and immediately wash
the clothes in cold water to avoid stains.
(Back View)
V