Fuji Xerox DocuPrint 203A Quick Setup Manual page 4

QSG_Eng.book Page IV Tuesday, April 26, 2005 11:03 AM
For installation & relocation
Do not place the machine near heaters or
volatile, flammable, or combustible materials
such as curtains that may catch fire.
Place the machine on a level and sturdy surface
that can withstand a weight of 6.55 kg. If tilted,
the machine may fall over and cause injuries.
Do not place the machine in a hot, humid, dusty,
or poorly ventilated environment. Prolonged
exposure to these adverse conditions can cause fire
or electric shocks.
The machine has ventilation holes on both sides.
Ensure that the machine is installed with a
minimum clearance of 100 mm from the vent to the
wall. A poorly ventilated machine can cause
excessive internal heat and fire. The accompanying
diagram shows the minimum clearances required for
normal operation, consumables replacement, and
maintenance to ensure your machine operates at
peak performance.
100mm
When moving the machine, be sure to unplug the
power cord from the outlet. If the machine is
moved with the power cord connected, it can cause
damage to the cord which could result in fire or
electric shocks.
When moving the machine, do not tilt it more
than 5 degrees. If tilted excessively, the
machine may fall over and cause injuries.
5
5
The Ethernet cable is for indoor use only.
External use will result in premature damage
from the elements.
For power & earth connection
Two power specifications are listed below. The
specifications that apply to your machine depend
on your machine configuration. Connect the power
plug only to a properly rated power outlet. Otherwise,
it can cause fire or electric shocks. If in doubt, contact
IV
100mm
100mm
5
5
our Customer Support Centre or your dealer.
- Rated voltage 100 to 120 V, 8.6 A
Rated frequency 50/60 Hz
- Rated voltage 220 to 240 V, 4.3 A
Rated frequency 50/60 Hz
Ensure that the plug connection is free of dust. In
a damp environment, a contaminated connector
can draw a non-negligible amount of current that can
generate heat and eventually cause fire over an
extended period of time.
Do not attempt to rework, pull, bend, chafe, or
otherwise damage the power cord. Do not place
a heavy object on the cord. A damaged cord can
cause fire or electric shocks.
Never touch a power cord with wet hands.
Danger of electric shock exists.
Stop operation immediately if your machine
produces smoke, excessive heat, unusual noise,
or smell, or if water is spilt onto the machine. These
conditions can cause fire. Immediately switch off and
unplug the machine, and contact our Customer
Support Centre.
Plug the power cord directly into a grounded
electrical outlet easily accessible. Do not use an
extension cord. If you do not know whether an outlet
is grounded, consult a qualified electrician. Improper
connection of the equipment-grounding conductor
can result in an electric shock.
If the power cord is broken or insulated wires are
exposed, ask our Customer Support Centre or
your dealer for a replacement. Using a damaged cord
can cause fire or electric shocks.
Use only the power cord specified for this printer.
Using a different cord may cause fire or electric
shock. Do not use the machine's power cord on any
other equipment.
Connect this product to a LAN connection that is
not subjected to overvoltages. (For DocuPrint
204A only)
Do not unplug or replug the machine while it is
on. Unplugging a live connector can deform the
plug and cause fire.
When unplugging the machine, grasp the plug
instead of the cord. Forcibly pulling on a cord can
damage it and cause fire or electric shocks.