Walchem W600 Instruction Manual page 72

Status
Name
Code
43 Unused
44 Sensor Input Failure
45 Sensor Fault Error
46 Sensor Range Alarm
47 Relay Cycle Delay
48 Sensor Normal
49 Sensor Initializing
50 Sensor Default Temp
51 Alarm Relay: Open
52 Alarm Relay: Closed
53 Probe Wash: Relay Off
54 Disabled
55 Duty Cycle: Off
56 VI Calculation Error
57 Output On Delay
58 Output Off Delay
59 DI Flow Verify: Off
60 DI Flow Verify: Auto
61 Output PID Saturated: High
62 Output PID Saturated: Low
63 Output Lead Lag
64 DI Flow Verify: Reprime
65 Spike Onset
66 Spike Event: On
67 Spike Event: Off
68 Stabilizing
69 Circuit Test
70 Cable Test
71 Circuit Cal
72 Polarization
73 Imbalance
74 Resistance
75 Enabled
76 Invalid Config
77 Connecting
78 Network Not Found
79 Invalid Key
80 Unable To Connect
81 Connected
82 Ad-Hoc Idle
83 Ad-Hoc Connected
Sensor input failure or sensor board alarm.
Sensor value outside of fault limits.
Sensor value outside of range limits.
Relay state change delayed by minimum cycle time setting.
Sensor is running in normal operation.
Sensor input is initializing.
Sensor using default temperature instead of sensor value.
Alarm Output relay closes on an alarm.
Alarm Output relay opens on an alarm.
Probe Wash in progress for input sensor.
Object is disabled.
Relay is off due to duty cycle settings.
Calculation error while evaluating a virtual input.
Relay is off waiting for on delay to expire.
Relay is on waiting for off delay to expire.
DI Flow Monitor reports an error, output is forced off.
DI Flow Monitor reports an error, output is in auto mode.
PID integral hold due to output saturated at 100%.
PID integral hold due to output saturated at 0%.
Lag is controlling (or being controlled) in automatic mode.
DI Flow Monitor reports an error, output is forced on.
Spike onset climb active before reaching spike setpoint.
Spike onset value achieved, event in progress, output on.
Spike onset value achieved, event in progress, output off.
Sensor input is in a stabilization delay
Corrosion Sensor circuit self-test in progress
Corrosion Sensor cable test in progress
Corrosion Sensor circuit calibration in progress
Corrosion Sensor polarization measurement in progress
Corrosion Sensor imbalance measurement in progress
Corrosion Sensor solution resistance measurement
Ethernet or WiFi communications enabled
WiFi configuration settings invalid
WiFi connection in progress
WiFi infrastructure network not available
WiFi security key for infrastructure network invalid
WiFi unable to connect to infrastructure network
WiFi infrastructure network connection successful
WiFi ad-hoc mode available and not currently connected
WiFi ad-hoc network connection successful
72
Description