RIDGID SeekTech SR-20 Operator's Manual page 50

Signal Quality
You can monitor the SR‑24's internal GPS receiver sig‑
nal quality from the GPS menu� To open the GPS menu,
follow these steps:
1� Open the Settings menu and press the Down Arrow
Key to navigate to the GPS icon
2� Press the Select Key
3� Press the Down Arrow Key
Signal Quality icon
Key to open the Signal Quality screen�
Each bar indicates the signal quality of different satel‑
lites� Higher numbers indicate better signal quality� Signal
quality can be affected by the availability of a clear view
to the signal and by the number of satellites that are cur‑
rently available�
GPS Information
To view the GPS Information screen, follow these steps:
1� Open the Settings menu and press the Down Arrow
Key to navigate to the GPS icon
2� Press the Select Key
3� Press the Down Arrow Key
Information icon
Key �
GPS Module
GPS Firmware
Date of Build
Note: GPS is always on. To disable GPS data from log-
ging to the internal SD card or your Bluetooth device,
refer to the Disable Data section.
50 – English
�
to open the GPS menu�
to navigate to the
and press the Select
�
to open the GPS menu�
to navigate to the
and press the Select
Time Zone
Change the time zone setting in the Time Zone screen�
To change the time zone, open the Settings menu and
press the Down Arrow Key
Zone icon � Press the Select Key
through time zones� Press the Menu Key
exit�
Note: Look up your time zone code at 24timezones.com
LCD Backlight
The SR‑24 has a light sensor built into the Keypad that
can automatically adjust the LCD backlight� The default
setting, Auto, is configured to automatically turn on the
backlight for the LCD in low light conditions�
To change the backlight settings, open the Settings
menu and press the Down Arrow Key
the Light Bulb icon
to toggle between the "On," "Off," and "Auto" backlight op‑
tions� Press the Menu Key
Auto-shutdown
By default, the SR‑24 powers off automatically if no
Keys are pressed for over one hour� If you disable Auto‑
shutdown the SR‑24 will stay powered on until the batter‑
ies are fully discharged�
To change the Auto‑shutdown setting, open the Settings
menu and press the Down Arrow Key
the Clock icon
toggle between one hour and off
Menu Key to save and exit�
to navigate to the Time
to cycle
to save and
to navigate to
� Press the Select Key
to save and exit�
to navigate to
� Press the Select Key
� Press the
to