RIDGID SeekTech SR-20 Operator's Manual page 39

Direct Connect Mode and Inductive Mode
To remotely set the transmitter to direct connect mode
or inductive mode using the receiver, open the transmit‑
ter control screen� Press the Select Key
tween direct connect mode and inductive mode�
Clamp Mode
The receiver can see the transmitter's clamp mode but
cannot turn the transmitter's clamp mode on or off� An
inductive clamp must be connected to access clamp
mode� Refer to the operator's manual for your transmitter
and inductive clamp for more information on using induc‑
tive clamp mode�
Output Power
Higher output settings produce a stronger signal for
the receiver, but reduces battery life for the transmitter�
Only use 1,000 mA High Output Mode if using an 18 V
to toggle be‑
Lithium‑ion rechargeable battery, external power, or high
capacity NiMH D cell batteries� Do not use the ST‑33Q+
in high output mode with standard alkaline batteries�
You can read the transmitter's output power or change it
remotely from the receiver� To remotely change the trans‑
mitter's output power using the receiver, open the trans‑
mitter control screen� Press the receiver's Up and Down
Arrow Keys to adjust the output power�
English – 39