Sd Card - RIDGID SeekTech SR-20 Operator's Manual

SD Card

The following section applies to the SR-24 only.
The Data Output feature sends the SR‑24's locate data
to the internal SD card, or to a Bluetooth device if one
is available, or to both simultaneously� Full data logging
is enabled by default, and you can disable an entire
category or specific elements within a category� Refer
to Appendix C for descriptions of the data logging ele‑
ments�
Note: Refer to the Data Output section for instructions
on how to disable and enable entire categories or spe-
cific elements within a category.
Data can be logged continuously (default), or manual‑
ly at specific points during a locate, by enabling User‑
Initiated Data Output� When User Initiated Data Output is
enabled, continuous data logging is turned off, resulting
in a log file that contains only the information you want�
40 – English
Data Logging
To disable data logging from the SD Card menu, follow
these steps:
1� Press the Menu Key
2� Use the Down Arrow Key
Card icon
3� Press the Select Key
4� Highlight the Logging icon
the Select Key to toggle between "On" (default)
and "Off" �
5� Press the Menu Key
Note: The SR-24 is compatible with Bluetooth 2.0 devic-
es including many phones, tablets, and GPS units. Refer
to www.RIDGID.com/SR24 for a list some models that
have been tested to work with the SR-24.
to open the Main Menu�
to highlight the SD
�
to open the SD Card menu�
and press
to save and exit�