RIDGID SeekTech SR-20 Operator's Manual page 36

Bluetooth Auto-Connect
After connecting for the first time, the SR‑24 no longer
requires a pin to connect to that Bluetooth device� When
the SR‑24 is powered on, it automatically searches for
any device that has previously connected to� The SR‑24
automatically connects if it is within range of a previously
connected device and the device is available�
Note: The device does not need to be discoverable to
reconnect to the SR-24.
The SR‑24 can save up to sixteen Bluetooth devic‑
es� When maximum capacity is reached and a new
Bluetooth device is added, the SR‑24 replaces an old
Bluetooth device with the new Bluetooth device in the
list below the Search icon
Options menu�
The SR‑24 continues to attempt to auto‑connect if you
disconnect the Bluetooth connection from your Bluetooth
device� To disconnect an automatically connected de‑
vice from the SR‑24 you must do so from the SR‑24's
Bluetooth menu� Refer to the Disconnecting Bluetooth
section for instructions on how to disconnect Bluetooth�
Once you have disconnected an auto‑connected de‑
vice from the SR‑24, no further automatic connection
attempts will be made for the remainder of that power
cycle� When the SR‑24 is powered off and then powered
on, the Bluetooth reinstates its default setting and at‑
tempts to auto‑connect to any previously connected de‑
vice within range�
The SR‑24 searches for all previously connected devic‑
es within range� The SR‑24 connects to the previously
connected device that is available� If more than one pre‑
viously connected device is in range and available, the
SR‑24 attempts to connect to one, beginning at the top of
the list, and going down the list until connected�
If you want to connect to a device that the SR‑24 did not
automatically connect to, follow these steps:
1� Press the Menu Key
2� Use the Down Arrow Key
Bluetooth Options icon
36 – English
in the Bluetooth
to open the Main Menu�
to highlight the
�
3� Press the Select Key
Options menu�
The name of the previously connected device ap‑
pears with an asterisk below the Search icon
in the Bluetooth Options menu� The fol‑
lowing image shows
previously been connected to the SR‑24�
4� Use the Down Arrow Key
you want to connect to�
5� Press the Select Key
specific device that has previously been connect‑
ed to�
If you are no longer using a Bluetooth device, you can
remove it from the list of previously connected devices,
follow these steps:
1� Open the list of previously connected devices� Use
the Down Arrow Key
want to remove from the list�
2� Press and hold the Select Key
ond�
3� Press the Select Key
vice from the list of previously connected devices
or press the Menu Key
screen�
to open the Bluetooth
as a device that has
to highlight the device
to connect the SR‑24 to a
to highlight the device you
for about one sec‑
to delete the Bluetooth de‑
to return to the previous