Removing The Temporary Assembly Pins; Installing The Tractioners - Carefree Universal Eclipse Installation Manual

E
CLIPSE
R T
EMOVING THE
2 pins are inserted into the back of the left (idler) head for lateral stability
during installation. Using a pair of pliers, remove and discard both pins.
NOTE: The awning will operate with the pins in place; for long term use,
the pins must be removed to allow for climate variances.
I
NSTALLING THE
The tractioners are used with the Alumaguard and Uniguard metal fabric wraps.
Keeper
A
Alumaguard or
Uniguard
A
1. Partially extend the awning until the Alumaguard/Uniguard is extended as shown.
2. Unlock the keeper and wrap the tractioner around the roller tube.
3. Position the tractioner under the Alumaguard/Uniguard with a 1/4" gap between Alumaguard/Uniguard
and tractioner. Lock the keeper.
4. Repeat for the other end of the rollbar.
5. Extend the awning to verify that the tractioners are lifting the metal wrap up and over the roller
assembly.
6. To secure the tractioner, drill a 1/8" hole through the tractioner and rollbar, roughly center the hole
between two slots of the rollbar.
7. Secure with one (1) #10 square drive screw.
16
Installation Manual
A
EMPORARY SSEMBLY
T
RACTIONERS
Position Tractioner under
Alumaguard/Uniguard
P
INS
1/4" Gap
(Alumaguard)
1/4" Gap
(Uniguard w/ Vinyl Fabric)
Carefree of Colorado
Place Screw
Between Slots
on Roller
A-A
View
Place Screw
Between Slots
A-A
View on Roller
052568-001r5
E0058