Checking The Contents Of The Box - Roland TD-3KW Owner's Manual

Checking the Contents of the
Box
❑ TD-3 (Percussion Sound Module) x 1
❑ KD-8 (Kick Trigger Pad) x 1
❑ FD-8 (Hi-Hat Control Pedal) x 1
❑ PDX-8 (V-Pad) x 1
❑ PD-8 (Pad) x 3
❑ CY-5 (Cymbal Pad) x 1
❑ CY-8 (Cymbal Pad) x 2
❑ Connection Cables
❑ Tuning Key x 1
■ TD-3KW Owner's Manual x 1
• The tuning key is included in the FD-8 package.
• The TD-3 Owner's Manual is included in the TD-3
package.
• This package does not include a kick pedal. Use with a
commercially available kick pedal.
• This package does not include the CY-5 attachment set
for cymbal.
962a
* In the interest of product improvement, the specifications and/
or appearance of this unit are subject to change without prior
notice.
TD-3
(Percussion Sound Module)
Attach the mounting plate (included with the optional drum stand) to the TD-3.
Using the screws attached to the bottom panel, attach the holder so the unit is oriented as shown in the diagram.
fig.TD-3.e
• To attach the stand holder, remove the four 8 mm
screws (M5 x 8) from the bottom of the TD-3 and
use them. Use of other screws may result in
damage to the unit.
928
• When turning the unit upside-down, get a bunch
of newspapers or magazines, and place them
under the four corners or at both ends to prevent
damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or
controls get damaged.
929
• When turning the unit upside-down, handle with
care to avoid dropping it, or allowing it to fall or
tip over.
4
MDS-3C
(Drum Stand)
Assemble the Drum Stand.
About the Stand, refer to the owner's manual for the
stand.
Do NOT open the legs of the stand at more than 120
degrees, and NOT make the distance of both Right/Left
end legs as more than 90cm (36 inches). If you do so, the
stand could fall down.
120˚
90 cm (36 inches)
Narrow
120˚
Wide