Troubleshooting - Jura Impressa Xs9 OT Operating & Cleaning Instructions

Troubleshooting:

Milk flow
No milk flow
Milk spluttering
Not filling cups
Froth milk is flat & cool
Solution:
1. Remove the air suction.
2. Check the valve on the tip of the air suction is clean and is able to open and close freely. Squeeze the valve
between your figures, it should open, release it and it should close.
3. Refit the air suction. Turn the milk selector to the froth position
still occurring replace the air suction and test again. If the problem has been solved, order in a spare air
suction (Part no. 71210) otherwise go to step 4.
4. Remove the auto frother from the machine.
5. Separate the auto frother into 4 parts.
6. Soak plastic / rubber parts in 250ml of warm water and 15 ml of Cafetto red weekly cleaner for 30 min.
7. Clean the milk and air paths with the cleaning brush (Part no. 71161)
8. Rinse parts under tap water, re-assemble the auto frother and refit onto the machine.
9. Test the milk. If the problem has not been solved contact customer support on 1300 365 487.
Important: Do not soak metal / chrome parts to avoid possible damage.
Figure 1
Figure 6 - Milk
My Coffee Shop Pty Ltd
ACN 102 850 037
clientservices@mycoffeeshop.com.au
(Fig 1)
(Fig 5)
Figure 3 – Froth
Figure 2
Figure 7 - Milk Figure 8 - Air
1473-1475 Malvern Road
(Fig 3),
(Fig 4)
Figure 4
Figure 9 - Milk
Glen Iris Vic 3146
ph: 03 9946 4160
fax: 02 9629 8046
1300 365 487
(Fig 2)
and test the milk. If the problem is
(Fig 6 – 9)
Figure 5
93/1-5 Harwood Street
Pyrmont NSW 2009
www.mycoffeeshop.com.au
ph: 02 9034 6580
fax: 02 9629 8046