About The Function Buttons - Roland XV-88 Owner's Manual

About the Function Buttons

Function buttons are buttons that perform a variety of
functions. The function they perform will depend on the
current mode, and on whether [EDIT] is on (lit) or off
(extinguished). [EDIT] will turn on or off each time you press
it.
fig.01-11
[EDIT] switches the function of the function buttons, but
pressing [EDIT] will not make the display change. If you
wish to modify a setting, press the [EDIT] to make the
indicator light, and then press a function button to select
the display group and switch the display. When you
finish making settings, press [EXIT] or a mode button to
switch the display.
In Performance Mode
([EDIT] Indicator is Extinguished)
The Function buttons work as [ZONE SELECT] buttons that
switch each Zone's Local switch and Transmit switch on (lit)
and off (extinguished).
When the [LOCAL/TX] indicator is extinguished, the switch
has the linked Part for each Zone play (lit) or not play
(extinguished).
When the [LOCAL/TX] indicator is lit, the switch allows the
data describing all actions using the keyboard controller
section for each Zone to be sent (lit) or prevents it from being
sent (extinguished).
Since 16 Zones are being controlled using only 8 buttons, use
[1-8/9-16] to select the set of Zones you want to control.
When the [1-8/9-16] indicator is out, you can switch Zones
1–8 on/off. When it is lit, you can switch Zones 9–16 on/off.
If the [EDIT] indicator is turned off in the Part setting page,
the function buttons will act as PART Select buttons ([PART
SELECT]) that select the Part to be edited.
Chapter 1. Overview of the XV-88
In Patch Mode
([EDIT] Indicator is Extinguished)
The function buttons will act as Tone Switch buttons ([TONE
SWITCH]) and Tone Select buttons ([TONE SELECT]).
[TONE SWITCH] allow you to turn each Tone in the Patch
on (lit) or off (extinguished). When a Tone is turned on, it can
be heard.
Use [TONE SELECT] to select the Tone you wish to modify.
To select a Tone to modify, turn off [EDIT] indicator in the
Tone setting page. To select two or more Tones
simultaneously, hold down one of [TONE SELECT] and
press the other [TONE SELECT]. In this case, the numbers of
Tones other than the first-selected Tone will be displayed as *
symbols.
In Rhythm Set Mode
([EDIT] Indicator is Extinguished)
The function buttons (TONE SELECT section) will select the
key shown in the display.
If the [EDIT] indicator is turned off in the Rhythm Set setting
page (the setting page for individual keys), the function
buttons will select the key to be edited.
TONE SELECT [1]: move to an octave lower key
TONE SELECT [2]: move to the semitone below
TONE SELECT [3]: move to the semitone above
TONE SELECT [4]: move to an octave higher key
In GM Mode
([EDIT] Indicator is Extinguished)
The Function buttons work as [PART SELECT] buttons that
switch the reception of Note messages on (lit) and off
(extinguished).
Since 16 Parts are being controlled using only 8 buttons, use
[1-8/9-16] to select the set of Parts you want to control. When
the [1-8/9-16] indicator is out, you can switch Parts 1–8 on/
off. When it is lit, you can switch Parts 9–16 on/off.
If the [EDIT] indicator is turned off in the Part setting page,
the function buttons will act as PART Select buttons ([PART
SELECT]) that select the Part to be edited.
25