Roland XV-88 Owner's Manual page 136

Chapter 7. Adding Effects
32: ENHANCER CHORUS
This effect connects an enhancer and a chorus in series.
fig.MFX-32
L in
Enhancer
Mix
R in
Enhancer
Mix
Enhancer Sens (Enhancer Sensitivity) #
Adjust the sensitivity of the enhancer.
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Cho Dly (Chorus Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
ChoRate (Chorus Rate)
Adjust the modulation speed of the chorus effect.
Chorus Depth
Adjust the modulation depth of the chorus effect.
Chorus Balance #
Adjust the volume balance between the enhancer sound that
is sent through the chorus and the enhancer sound that is not
sent through the chorus. With a setting of "D100:0W," only
the enhancer sound will be output. With a setting of
"D0:100W," only the enhancer sound that is sent through the
chorus will be output.
Level (Output Level)
Adjust the output level.
136
L out
Balance D
Balance W
Chorus
Balance W
R out
Balance D
33: ENHANCER FLANGER
This effect connects an enhancer and a flanger in series.
fig.MFX-33
L in
Enhancer
Mix
R in Enhancer
Mix
Enhancer Sens (Enhancer Sensitivity) #
Adjust the sensitivity of the enhancer.
Enhancer Mix (Enhancer Mix Level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Flg Dly (Flanger Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
FlgRate (Flanger Rate)
Adjust the modulation speed of the flanger effect.
Flg Dpt (Flanger Depth)
Adjust the modulation depth of the flanger effect.
Flg Fbk (Flanger Feedback Level)
Adjust the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Flanger Balance #
Adjust the volume balance between the enhancer sound that
is sent through the flanger and the enhancer sound that is not
sent through the flanger. With a setting of "D100:0W," only
the enhancer sound will be output. With a setting of
"D0:100W," only the enhancer sound that is sent through the
flanger will be output.
Level (Output Level)
Adjust the output level.
Balance D
L out
Feedback
Balance W
Flanger
Balance W
R out
Balance D