Start Recording; Stop Recording - Roland RM-700 Owner's Manual

Recording and Saving the Performance
5.
Touch <NewSong>.
The [ (Play/Stop)] button will blink, and the RM-700 will enter recording-standby mode.
6.
Decide on the tempo and beat.
If necessary, press the [Metronome] button to play the metronome.
When you have finished making the settings, press the [Exit] button to display the Basic screen.

Start Recording

7.
Press the [
A two-bar count-in plays, then recording starts.
Even without pressing the [
when you start by playing rather than pushing the [
When recording starts, the [

Stop Recording

8.
Press the [
Recording stops.
The performance is recorded to the [Right] button.
Play Back the Recorded Performance
9.
Press the [
The recorded performance is played back.
When you press the [
Track Buttons Assignments for Recorded Performances
When you record only a keyboard performance, the performance will be assigned to the track buttons as follows.
• Normal performance (playing a single Tone from the entire keyboard)
The performance is recorded to the [Right] button.
• Layer performance
The performance is recorded to the [Right] button.
• Split performance
The lower part of the keyboard is recorded to the [Left] button, and the upper part of the keyboard is recorded to the
[Right] button.
• Layer performance and Split performance
The lower part of the keyboard is recorded to the [Left] button, and the upper part of the keyboard is recorded to the
[Right] button.
• Drum set or sound effect performance
Recorded on the [Accomp] button.
126
(Play/Stop)] button.
(Play/Stop)] button, recording starts when you play the keyboard. There is no count-in played
(Play/Stop)] and [
(Play/Stop)] button.
(Prev)] button, then press the [
(Play/Stop)] button, playback stops.
(Play/Stop)] button.
(Rec)] buttons' indicators light up.
(Play/Stop)] button.