Dc Power Supply - Skyrc e660 Instruction Manual

DJI Mavic Battery Program
This charger is capable of charging, storage DJI Mavic smart battery.
Charging Mode
Connect the battery to the
charger as show on the diagram.
Mavic charging cable(SK-
600023-06) is not included in the
package. You need purchase it
separately.
Turn ON the battery before you
put it in charging mode.
Press the Power Button once
BATT/PROGRAM
Click +/- to locate DJI Mavic BATT program
DJI Mavic BATT
Click ENTER to get into CHARGE mode
LH3S CHARGE
Press and hold START/ENTER for 3 seconds to
TURN ON BATTERY
start the program.
Storage Mode
When the battery is idle for more than ten days. It is better to discharge
the battery to 65% of total power in order to prevent swelling. If the
battery level is below 65%(15.6V), you need recharge it to 65%.
Turn ON the battery before you put it in storage mode.
BATT/PROGRAM
Click +/- to locate DJI Mavic BATT program
DJI Mavic BATT
· 26
CONNECTION DIAGRAM
Note: Mavic charging cable is not included in the package
Press Again and Hold
for 2 Seconds to Turn On
e660
LH3S CHARGE
Click +/- to locate STORAGE mode
TURN ON BATTERY
Press and hold START/ENTER for 3 seconds to
LH3S STORAGE
start the program.
TURN ON BATTERY

DC Power Supply

To use e660 as a power supply, the user must connect it to AC power
source. When the green LED on the left side turns on, then the user is
free to use the power supply, the power of DC output is adjustable from
10W to 60W. The output voltage is 13.8V. The power of DC output is
shared with charger power. When you increase the power of DC output,
the charger power will be decreased accordingly. (DC Power + Charger
Power = 60 Watts)
DC Fan
Press the ENTER to enter the DC Power
BATT/PROGRAM
SYSTEM SETTING-> Supply program
ENTER
DC SUPPLY: OFF
Select the power of DC output.
CHARGE POWER: 60W
ENTER
Press ENTER, the power value will blink, click
DC SUPPLY: 25W
+/- to allocate the power.
CHARGE POWER: 35W
Caution: The maximum DC Power output is 60 Watts. Please check
your device loading before you allocate the power.
e660
DC Power Supply
EXPLANATION OF LED STATUS
OFF DC Power Off
Green 0-50% Loading
Yellow 51-75% Loading
Red 76-100% Loading
Red Blinking Over Load
27 ·