ABB ACS350 Installation Instructions page 2

Grounding
clamps
6. Install the clamp for the control cable, or if cables are run in
conduits, replace all clamps with suitable glands (not included).
Run cables through the clamps and tighten. Strip cable ends.
Fasten the grounding conductor (PE) of the input power cable
and the twisted shield of motor cable under the grounding
clamps. Connect the connectors to appropriate terminals. See
Electrical installation in the drive manual.
10
10. Fasten the hood to drive with two M3×12 screws.
11. Fasten the hood to wall with one M4 screw (not included).
ABB Oy AC Drives P.O. Box 184 FIN-00381 HELSINKI FINLAND Tel. +358 10 22 11, Fax: +358 10 22 22681, Internet: http://www.abb.com
Clamp
7. Install the gland box cover.
8. Fasten the cover with two M4×12 screws.
11
12. Drive with MUL1-R3 option installed.
9
7
8
9. Install the hood. First position the front edge carefully, then
press the hood downwards until it snaps on.