Roland DP-990 Owner's Manual page 55

2.
Press the [
The [
recording standby mode.
If you decide not to record, press the [
The button of the track to be recorded will flash.
3.
Press the button of each track you don't want to record, turning off its
illumination.
Recording
4.
Press the [
After two measures of count sound, recording begins.
Recording starts when you start playing the keyboard (without pressing the [
case, a count is not sounded.
When recording begins, the [
5.
To stop recording, press the [
Recording an additional part
If the "Int Song" indicator is not lit, press the [Int Song/Ext Song] button.
6.
Press the [
You will return to the beginning of the recorded performance.
7.
Press the [
8.
Press the button of the track you want to record, making it flash.
NOTE
The [
standby mode.
If you decide not to record, press the [
] button.
] button will light, the [
You can record to only one track button at a time.
] button.
During the count-in, the count measure is indicated in the display as "-2" then "-1."
] button.
] button.
If you select a previously recorded track, that track will be overwritten by the newly
recorded performance, and the previously recorded performance will be lost.
] button will light, the [
] button indicator will flash, and the DP-990 will enter
] button once again.
] button and [ ] button will light.
] button.
] button will flash, and the DP-990 will enter recording
] button once again.
Recording
] button). In this
55