Table of Contents
Advertisement
18. TIMER
Activates or adjusts some basic settings of
an onscreen timer.
19. D.ZOOM (+,-)**
Magnifies or reduces the projected picture
size.
When you are under the MHL connection mode and the projector OSD is off, these buttons are
available for controlling your smart device: arrow keys, OK/IMAGE, AUTO PC.
11, 13 and 15: arrows keys
Arrows keys are available for controlling your smart device.
16. OK/IMAGE
Use the key to confirm the selection on the OSD of your smart device.
14. AUTO PC
Use the key to return or exit the OSD menu of your smart device.
To enter the MHL connection mode, connect a MHL device and switch the input signal to HDMI1/
MHL.
** When the projector and computer are connected via USB, the function (Page UP/Page DOWN)
which operates the computer from the remote controller is set.
Remote control effective range
Infra-Red (IR) remote control sensors are located on the
front and top of the projector. The distance between the
remote control and the sensors should not exceed 8
meters (~ 26 feet).
Use the remote control within an angle approximately
30° in any direction from directly in front of the infrared
remote receiver.
Make sure that there are no obstacles between the
remote control and the IR sensors on the projector that
might obstruct the infra-red beam.
You may not be able to perform operations if there are
any obstacles between the remote control and the
projector.
You may not be able to operate the remote control if
direct sunlight or strong light is shining onto the remote
IR receiver.
The remote control may interfere with other equipment
or remote control.
26 Introduction
20. MUTE
Temporarily mutes the audio.
21. FREEZE
Freezes the projected image.
22. VOL (+,-)
Adjusts the sound level.
Advertisement
Table of Contents
