Remote Control Operating Range; Projector And Remote Control Buttons - Canon LV-HD420 User Manual

I L
TEM ABEL
11.
BLANK
12.
HDMI
13.
VIDEO
14.
MUTE
15.
VOLUME
16.
KEYSTONE
17.
STATUS
18.
3D
19.
ZOOM
20.
FREEZE
21.
BRIGHTNESS
22.
LAMP
23.
MENU
24.
AUTO
25.

Remote Control Operating Range

The remote control is an infrared type. Point it at the infrared remote receiver on the front or rear of
the projector to operate it. Remote control range is up to approximately 5 m (16') . Use the remote
control within an angle approximately 15° in any direction from directly in front of the infrared remote
receiver. But the effective control range may be reduced.

Projector and Remote Control Buttons

The projector can be operated using the remote control or the buttons on the top of the projector. All
operations can be carried out with the remote control; however, the buttons on the projector are
limited in use.
D
Toggles the screen between blank and normal.
Also, toggles the built-in speaker between off and on.
Toggles the input sources for display between HDMI sources.
Toggles the input sources for display between Video and S-Video.
Toggles the built-in speaker between off and on.
Displays the volume setting bar.
Displays the keystone setting bar.
Opens the OSD Status menu. (the menu only opens when
an input device is detected)
Opens the 3D function OSD.
Displays the zoom setting bar.
Freeze/unfreezes the on-screen picture.
Displays the brightness setting bar.
Displays the lamp mode selection.
Opens and exits OSD menus.
Auto adjustment for frequency, phase, position.
Navigates and changes settings in the OSD.
Keystone correction.
– 20 –
ESCRIPTION
S
EE PAGE
28
27
46
29