Table of Contents
Advertisement
Installation to Project Up, Down, or at an Angle
Caution
Precautions for Portrait (Upright) Installation
Caution
• Projection is possible upward, downward, or in a variety of directions,
but do not block the air intake and exhaust vents. In particular, always
ensure a minimum clearance of 2 cm (0.8") from the air intake vent on
the bottom, 50 cm (1.6') from the air intake/exhaust vents on the both
sides of the projector.
• There are no options for installing the projector.
• Do not attempt to install the projector for upward or downward
projection by yourself. Always request installation by a qualified
technician or the Canon Customer Support Center.
• Referring to the following illustration ,when the projector is installed in
a tilt angle over ±45 degrees, you need to select 360 & Portrait at the
Light Source Mode in the Light Source Settings menu.
• Do not block the air intake or exhaust vents. In particular, because
there are air intake/exhaust vents, always ensure a minimum
clearance of 2 cm (0.8") from the right side, 50 cm (1.6') from top and
bottom sides.
• Note that the projector can only be positioned as illustrated above (not
the other way around).
• When the projector is installed in a portrait position, 360 & Portrait at
the Light Source Mode in the Light Source Settings menu.
Before Installation
19
Advertisement
Table of Contents
