Table of Contents
Advertisement
Caution
16
For Safe Use
• Be careful of condensation.
If the projector is abruptly taken to a warmer location, or if the room
temperature rises abruptly, moisture in the air may condense on
the lens and mirror, causing the image to become blurred. In this
case, wait a while and make sure the moisture has evaporated
before resuming use.
• Do not install the projector in a location where the temperature is
high or low. Doing so may cause a malfunction. The temperature
range for operation and storage are as follows.
Operating temperature: 0°C to 40°C (32°F to 104°F)
Humidity: up to 90%
Storage temperature: -10°C to 65°C (14°F to 149°F)
• When using the projector at an altitude of 1,201 m (3,940') to
3,000 m (9,843'): From the projector menu, set
Mode"
to On.
(page
• Do not block the air intake or exhaust vents. Blocking the vents
may trap heat inside the projector, which may shorten the useful
life of optical components or other parts and damage the projector.
• Install the projector leaving at least 50 cm (1.6') between air
intake/exhaust vents and walls on each side of the projector. Leave
a gap of at least 2 cm (0.8") from the bottom of the projector. There
is an air intake underneath the projector. Failure to leave enough
space may trap heat inside the projector and damage it.
At least 30
cm (1.0')
At least 50 cm
At least 50 cm
(1.6')
• Do not place any objects on top of the projector that may change
shape or color due to heat.
• Do not install the projector near high-voltage electrical power lines
or an electrical power source.
49)
At least 50 cm (1.6')
(1.6')
"High Altitude
At least 2 cm
(0.8")
Advertisement
Table of Contents
