Making Connections - Raymarine RVX1000 Installation Instructions Manual

Item Connector
3
4
Note: A dust cap is provided for each transducer connector. Ensure that you fit the dust cap over
any unused transducer connector.

Making connections

Follow the steps below to connect the cable(s) to your product.
1. Ensure that the vessel's power supply is switched off.
2. Ensure that the device being connected to the unit has been installed in accordance with the
installation instructions supplied with that device.
3. Ensuring correct orientation, push the cable connector fully onto the corresponding connector
on the unit.
4. Turn the locking collar clockwise to secure the cable.
Cables and connections
Connects to:
• RealVision™ 3D transducers
• DownVision™ transducers
• CPT-S CHIRP conical beam
transducers
• Wide Beam CHIRP transducers
• CHIRP transducers
• Traditional transducers
Suitable cables
• Transducer's fitted cable
• Extension cable
• Adaptor cable
• Transducer's fitted cable
• Extension cable
• Adaptor cable
59