Omnitron Systems Technology RuggedNet GPoE+/Si User Manual

Unmanaged 4 and 8-port poe/poe+ switch

Advertisement

Quick Links

RuggedNet
GPoE+/Si
Unmanaged
4 and 8-Port PoE/PoE+ Switch
User Manual
38 Tesla, Irvine, CA 92618 USA
Phone: (949) 250-6510; Fax: (949) 250-6514
General and Copyright Notice
This publication is protected by U.S. and international copyright laws. All rights reserved. The whole
or any part of this publication may not be reproduced, stored in a retrieval system, translated,
transcribed, or transmitted, in any form, or by any means, manual, electric, electronic, electromagnetic,
mechanical, chemical, optical or otherwise, without prior explicit written permission of Omnitron
Systems Technology, Inc.
The following trademarks are owned by Omnitron Systems Technology, Inc.: FlexPoint
FlexSwitch
, HybridNID
, iConverter
, miConverter
TM
®
®
RuggedNet
, Omnitron Systems Technology, Inc.
TM
All other company or product names may be trademarks of their respective owners.
The information contained in this publication is subject to change without notice. Omnitron Systems
Technology, Inc. is not responsible for any inadvertent errors.
Warranty
This product is warranted to the original purchaser (Buyer) against defects in material and
workmanship for a period of two (2) years from the date of shipment. A five (5) warranty may be
obtained by the original purchaser by registering this product at www.omnitron-systems.com/support
within ninety (90) days from the date of shipment. During the warranty period, Omnitron will, at its
option, repair or replace a product which is proven to be defective with the same product or with a
product with at least the same functionality.
For warranty service, the product must be sent to an Omnitron designated facility, at Buyer's expense.
Omnitron will pay the shipping charge to return the product to Buyer's designated US address using
Omnitron's standard shipping method.
Limitation of Warranty
The foregoing warranty shall not apply to defects resulting from improper or inadequate use and/
or maintenance of the equipment by Buyer, Buyer-supplied equipment, Buyer-supplied interfacing,
unauthorized modifications or tampering with equipment (including removal of equipment cover by
personnel not specifically authorized and certified by Omnitron), or misuse, or operating outside the
environmental specification of the product (including but not limited to voltage, ambient temperature,
radiation, unusual dust, etc.), or improper site preparation or maintenance.
No other warranty is expressed or implied. Omnitron specifically disclaims the implied warranties of
merchantability and fitness for any particular purpose.
The remedies provided herein are the Buyer's sole and exclusive remedies. Omnitron shall not
be liable for any direct, indirect, special, incidental, or consequential damages, whether based on
contract, tort, or any legal theory.
Environmental Notices
The equipment covered by this manual must be disposed of or recycled in accordance with the
Waste Electrical and Electronic Equipment Directive (WEEE Directive) of the European Community
directive 2012/19/EU on waste electrical and electronic equipment (WEEE) which, together with
the RoHS Directive 2011/65/EU, for electrical and electronic equipment sold in the EU after July
1, 2006. Such disposal must follow national legislation for IT and Telecommunication equipment in
accordance with the WEEE directive: (a) Do not dispose waste equipment with unsorted municipal
and household waste. (b) Collect equipment waste separately. (c) Return equipment using collection
method agreed with Omnitron.
The equipment is marked with the WEEE symbol shown to indicate that it must be
collected separately from other types of waste. In case of small items the symbol
may be printed only on the packaging or in the user manual. If you have questions
regarding the correct disposal of equipment go to www.omniton-systems.com/support
or e-mail to Omnitron at intlinfo@omnitron-systems.com.
, NetOutlook
, OmniLight
, OmniConverter
TM
®
®
, OST
and the Omnitron logo.
TM
TM
Page 2
TM
,
,
TM

Advertisement

Table of Contents
loading

Summary of Contents for Omnitron Systems Technology RuggedNet GPoE+/Si

  • Page 1 Omnitron Systems Technology, Inc. The following trademarks are owned by Omnitron Systems Technology, Inc.: FlexPoint FlexSwitch , HybridNID...
  • Page 2: Product Overview

    1) Configure DIP-switches The GPoE+/Si automatically negotiates and delivers the power level required by its DIP-switches are located on the side of the RuggedNet GPoE+/Si. The DIP-switches Powered Device (PD) partner. When negotiating to PoE (IEEE 802.3af) it delivers are used to configure modes of operation, networking features and PoE reset.
  • Page 3: Sw1 And Sw2: Mode Of Operation

    The table below provides a description of each DIP-switch position and function. Directed Switch Mode When an 4-Port model is configured for Directed Switch Mode, traffic from Ports Switch 1 Fiber Port 2 Fiber Ports P1 - P4 is only forwarded to the fiber uplink port F1, preventing the broadcast traffic Mode Of Operation from flooding other network ports.
  • Page 4: Sw3 And Sw4: Fiber Redundancy

    Two fiber ports models can be configured for Directed Switch Mode and Fiber On the 4-Port models configured for Dual Device Mode and Directed Switch Mode, Redundancy (per DIP-switches 3 and 4), traffic is forwarded to both the primary the traffic from Ports 1 - 2 is only forwarded to fiber port F1 and Ports 3 - 4 are only and secondary fiber ports.
  • Page 5 drop PoE power when a loss of receive link on F1 is detected and RJ-45 ports 3 - 4 will drop PoE power when a loss of receive link on F2 is detected. On the 8-Port models, RJ-45 ports 1 - 4 will drop PoE power when a loss of receive link on F1 is detected and RJ-45 ports 5 - 8 will drop PoE power when a loss of receive link on F2 is detected.
  • Page 6: Verify Operation

    4) Verify Operation Verify the GPoE+/Si is operational by viewing the LED indicators. Power LED Indicators Legend Indicator Description Unit not powered Top View with DC Power Connector Green - ON Unit powered WARNING!!! Amber - ON Over temperature condition NEVER ATTEMPT TO OPEN THE CHASSIS OR Power LED Indicators SERVICE THE POWER SUPPLY.
  • Page 7: Specifications

    Specifications RJ-45 Ports LED Indicators RuggedNet GPoE+/Si Legend Indicator Description Description 10/100/1000BASE-T to 1000BASE-X No link Ruggedized Unmanaged PoE+ Ethernet Switch Green - ON Port linked at 100Mbps Standard IEEE 802.3, IEEE 802.3af (15.40 watts max), Compliances IEEE 802.3at (30 watts max)
  • Page 8: Customer Support Information

    Customer Support Information If you encounter problems while installing this product, contact Omnitron Technical Support: Phone: (949) 250-6510 Fax: (949) 250-6514 Address: Omnitron Systems Technology, Inc. 38 Tesla Irvine, CA 92618, USA Email: support@omnitron-systems.com URL: www.omnitron-systems.com 040-09560-001A 10/17 Page 15...

Table of Contents