INTRODUCTION Table of Contents General Description The 6700-FK is the direct replacement for the discontinued FlexSwitch Model INTRODUCTION ..............3 600XC 8U. The 6700-FK replacement kit consists of two iConverter 4Tx General Description ............. 3 Switch Modules installed in a iConverter 2-Module chassis. INSTALLATION ..............
UTP Installation DC Powered Chassis Mounting • Connect the UTP port via a Category 5 cable to a 10Base-T or 100Base-Tx Locate the DC circuit breaker, and switch the circuit breaker to the OFF Ethernet device. position. • Prepare a power cable using a three conductor insulated wire (not supplied) CONFIGURATION with a 14 AWG gauge minimum.
Configuring the DIP-Switches UTP 10/100Mbps “10/100” DIP-Switch (Port 1 or Port 2) When the UTP “AN/MAN” DIP-Switch (described above) is in the manual The 6700-FK has been pre-configured with Auto-Negotiation enabled for plug “MAN” position, the “10/100” DIP-Switch determines the speed of operation and play ease of use.
LED INDICATORS SPECIFICATIONS Switch Module Description 8 Port 10/100 Auto-Sensing Switch Each 4-Port Switch Module has LED indicators to provide connection Protocols 10Base-T, 100Base-Tx, information. with 1536 bytes max. frame size UTP Cable Type EIA/TIA 568A/B Category 5 and higher 4 Port Switch Module UTP Connector Type RJ45...
To avoid electrical shock, do not perform any servicing of this Support. unit other than that contained in the operating instructions, unless you are Phone: 800-675-8410 qualified and certified to do so by Omnitron Systems Technology, Inc. 949-250-6510 Caution Fax: 949-250-6514 All user-required operations can be performed without opening the unit.
Need help?
Do you have a question about the FlexSwitchTM 8U 6700-FK and is the answer not in the manual?
Questions and answers