Installation - NAMCO Prop cycle Operator's Manual

4. INSTALLATION

Notes on Installation
DANGER
DANGER
WARNING
NOTE
NOTE
NEVER turn the power to the machine ON until installation has
been completed.
In order to avoid injury or damage to the machine due to mis-
operation, ensure that the voltage of the mains supply is
230volts AC.
Also, in order to prevent possible electric shocks, be sure that
the machine is connected to the mains supply with a securely
connected earthed plug.
If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level
adjusters to prevent the machine sliding on the floor.
So that customers are not injured by the movement of the Cycle,
ensure that there is at least 500mm separation between other
machines or walls.
In order to gain access to the Power Supply and CPU assemblies,
make sure that the rear of the main cabinet is separated from a
wall or other machine by at least 500mm.
Page 8