Fan Motor Test - NAMCO Prop cycle Operator's Manual

e. When the start button has been pressed, the following screen is
displayed.
I/O TEST
TO EXIT : PUSH START AND HANDLEBARS UP
f. If "OK" is displayed the pedals are correct.
If "NG" is displayed there has been a problem in reading the pedal
rotation. Press start and repeat steps c) and d) again.
If "NG" is still displayed after repeating the test, there is the
possibility that the sensor board or sensor sticker is faulty.
g. Press the start button while pulling back on the handle bars, to return
to the "I/O Test" menu.
5-3-3-3

Fan Motor Test

a. Select "MOTOR" on the menu screen and press the start button. The
following screen is displayed.
I/O TEST
START : ENTER
b. When the start button is pressed once, 'OFF' changes to 'ON' and
the fan motor starts and blows air from the front of the cabinet. When
the start button is pressed again, 'ON' changes to 'OFF' and the fan
motor stops.
c. Select "EXIT" and press the start button to return to the "I/O Test"
screen.
DIP 12345678
SWITCH
PEDAL
PEDAL C5CF
E N D
O K
RETRY : PRESS START
DIP 12345678
SWITCH
PEDAL
MOTOR
FAN MOTOR OFF
EXIT
UP/DOWN : CHOOSE
Page 19