Notices - Dynacord TGX10 Installation Manual

TGX 4-Channel Power Amplifier
Notice!
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules and EN55032. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
1.5

Notices

Old electrical and electronic appliances
Electrical or electronic devices that are no longer serviceable must be collected separately and
sent for environmentally compatible recycling (in accordance with the European Waste
Electrical and Electronic Equipment Directive).
To dispose of old electrical or electronic devices, you should use the return and collection
systems put in place in the country concerned.
Copyright and disclaimer
All rights reserved. No part of this document may be reproduced or transmitted in any form by
any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior
written permission of the publisher. For information on getting permission for reprints and
excerpts, contact Dynacord.
All content including specifications, data, and illustrations in this manual are subject to change
without prior notice.
Dante is a registered trademark of Audinate Pty Ltd.
NEUTRIK, speakON, powerCON, and etherCON are registered trademarks of Neutrik AG.
IT security disclaimer
In order to offer maximum compatibility with all networked audio devices and to allow for fast
and easy setup and maintenance, our OMNEO-enabled amplifier products do not support
encrypted communications for audio or control data and do not verify the authenticity of any
Dante or OCA controllers (or any other node) on the network.
This means that these devices do not take any special precautions against malicious or
accidental attacks via their network interfaces. Such attacks happen every day on the public
internet. It is strongly recommended to set up the system in a safe, isolated network, meaning
a network where all hardware components are known and physically owned and none of them
is connected to the public internet.
Network cabling
The OMNEO network comprises audio transport using the Dante protocol as well as OCA
control commands. In order to guarantee the product performance according to
specifications, network cabling has to be shielded, fulfilling the requirements of CAT 5e as a
minimum.
For integration in networks, the network switches require a dedicated configuration. Further
details will be explained in the documentation of the related network control software.
Bosch Security Systems, Inc. Installation manual
Safety | en 7
2018.05 | 01 | F.01U.330.704