HPE FlexFabric 12900E Series Configuration Manual page 71
Virtual technologies
Hide thumbs
Also See for FlexFabric 12900E Series:
- Configuration manual (64 pages) ,
- Command reference manual (36 pages) ,
- Configuration manual (262 pages)
Table of Contents
Advertisement
[IRF-mdc-2-MDCA] quit
5.
Re-authorize the default MDC to use the two LPUs.
[IRF] mdc Admin
[IRF-mdc-1-Admin] location chassis 1 slot 2
[IRF-mdc-1-Admin] location chassis 2 slot 2
[IRF-mdc-1-Admin] quit
6.
Rebind HundredGigE 1/2/0/1 and HundredGigE 2/2/0/1 to IRF ports:
# Bind HundredGigE 1/2/0/1 to IRF-port 1/1.
[IRF] irf-port 1/1
[IRF-irf-port1/1] port group interface hundredgige1/2/0/1
[IRF-irf-port1/1] quit
# Bind HundredGigE 2/2/0/1 to IRF-port 2/2.
[IRF] irf-port 2/2
[IRF-irf-port2/2] port group interface hundredgige2/2/0/1
[IRF-irf-port2/2] quit
# Bring up the physical interfaces.
[IRF] interface range hundredgige 1/2/0/1 hundredgige 2/2/0/1
[IRF-if-range] undo shutdown
[IRF-if-range] quit
7.
Configure MDCA to enable remote access to MDCA:
# Log in to MDCA from the default MDC. Press Ctrl+D as prompted to stop automatic MDC
configuration and access the CLI of MDCA.
[IRF] switchto mdc MDCA
******************************************************************************
* Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
Automatic configuration is running, press CTRL_D to break or press CTRL_B to
switch back to the default MDC.
<IRF> system-view
# Change the device name to MDCA for easy identification of the MDC.
[IRF] sysname MDCA
# Assign an IP address to the management interface and configure Telnet login.
[MDCA] display interface m-gigabitethernet brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
M-GE1/0/0/0
M-GE1/0/0/1
M-GE1/0/0/2
M-GE1/0/0/3
[MDCA] interface m-gigabitethernet 1/0/0/2
[MDCA-M-GigabitEthernet1/0/0/2] ip address 192.168.2.251 24
[MDCA-M-GigabitEthernet1/0/0/2] quit
[MDCA] telnet server enable
Link Protocol Primary IP
DOWN DOWN
--
DOWN DOWN
--
UP
UP
--
DOWN DOWN
--
67
Description
*
*
*
Advertisement
Table of Contents
