Settings & Options - Honeywell PRO TH4110B Installation Manual

Installation Guide
Follow the procedure below to configure the thermostat to match the installed
heating/cooling system,
and customize feature
operation
as desired.
Press and hold both buttons
To begin, press and hold the A and V
buttons until the display changes
Function number Setting
Press Y to change settings
Press A to advance to next function
Press and hold Yak to exit and save settings
Setup Function
1 Systemtype
5 Heating cycle rate
(CPH: cycles/hour)
9 Compressor
cycle rate (CPH)
Settings & Options
0 Gas_ oil or electric heat with air conditioning
1 Heat pump (5 minute compressor off time in heating and cooling)
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
14 Temperature 0 Fahrenheit
display 1 Celsius
t5 Compressor
protection
5 Five-minute cempressor off time **See page 10
[Other options: 0, 1, 2, 3 or 4-minute off time]
J "3.. = "3 " ||l " "3
After completing the installer setup above, press the _k button again to begin a
system test (see next page).