Advertisement
GUI Interface Initiation
To access the GUI interface, first set up your local PC
LAN network adapter.
Windows System (Figure 3):
1. Go to Network and Sharing Center (Control
Panel −> Network and Internet −> Network and
Sharing Center).
2. Go to Change Adapter Settings and change your
local LAN network adapter settings:
IP address: 192.168.1.xxx (xxx = from 1 to 253,
make sure xxx p 168 since 192.168.1.168 is the
MatrixCam VDK default static IP address)
Subnet mask: 255.255.255.0 (default subnet mask
of the MatrixCam VDK)
Default gateway: 192.168.1.1
DNS server:
3. Push the power button to power on the camera.
LED3 and LED2 flash.
4. Use either the BLE or the PIR interrupt to wake up
the camera (see the section above).
5. Open up supported web-browser and enter the IP
address of the MatrixCam VDK: 192.168.1.168.
The GUI log-in page will pop up (Figure 4).
MacOs System:
1. Open Network Settings to set up network settings
(Figure 5). Go to System Preferences −> Network
Settings.
2. Repeat the steps 2, 3, 4, 5 above to access the GUI
log-in page.
EVBUM2306/D
Figure 3. LAN Network Adapter Settings (Windows)
www.onsemi.com
Figure 4. Log-In Page
Figure 5. LAN Network Adapter Settings (MacOS)
4
Advertisement
