Advertisement
Maintenance − Configuration
There are five configuration options available under
"Config" screen in "Maintenance" (Figure 21):
•
"Save" button: Click this button to save the current
configuration setting.
•
"Download" button: Click this button to download the
current configuration setting in CFG format into default
location.
Maintenance – Reboot
The MatrixCam VDK software reboot is available in case
of its abnormal operation. User can choose the particular
configuration setting and perform the MatrixCam VDK
restart with the selected configuration (Figure 22).
Figure 22. Software Reboot and Stand-By Mode Feature of the MatrixCam VDK
Maintenance – microSD Card
As mentioned in the video recording section above,
microSD card maintenance (remove/mount/format) is
available under the "SD Card" tab (Figure 16).
EVBUM2306/D
•
"Restore" button: Click this button to restore all the
settings to the factory default values.
•
"Upload" button: Click this button to upload any saved
configuration file.
•
"Delete" button: Click this button to delete the present
configuration setting.
Figure 21. Configuration Options
The MatrixCam VDK runs in disabled stand-by mode by
default after start-up, i.e the MatrixCam VDK does not go
to sleep mode and streams continuously. Optionally, user
can enable the stand-by mode and then the MatrixCam VDK
will go into a low power stand-by mode after 2 minutes of
being idle itself (Figure 22).
Maintenance – Firmware Upgrade using the GUI
An existing MatrixCam VDK firmware can be upgraded
via the GUI interface under "Firmware" tab (Figure 23−25).
It consists of system firmware and GainSpan Wi-Fi module
firmware.
www.onsemi.com
14
Advertisement
