Weather Dome Housing - Honeywell HD6 Series Installation Manual

2.5 WEATHER DOME HOUSING

WARNING: Installation must be performed by qualified technical
personnel and must be in accordance with all national and local
mechanical and electrical codes.
Perform the following steps to install a HD6 weather dome on a Honeywell Video
Systems outdoor mount with an ELL conduit fitting or an MDW1210W mount.
1. Select the location(s) of the housing (s). Each HD6 requires a 24Vac ± 10% power
source measured at the dome. Ensure a 24Vac @ 1.1A power source is available.
An additional 24Vac @ 4A power source is required for the heater/blower installed in
the weather dome.
2. Install the mount using the instructions provided with your specific mount. Run the
required field wiring and safety cable through the mount for the HD6 weather dome.
The field wiring and safety cable are the responsibility of the installer. Honeywell
Video Systems recommends using 3/32" plastic coated aircraft cable, part number
849518-0311, for the safety cable and looping sleeves, part number 849511-0057.
NOTE: Only the weather or pressurized domes with No Connector is compatible
with the MDW1210W mount.
3. Refer to
Refer to
Refer to
4. Locate the 1-1/2" NPT conduit nut shipped loose with the mount.
Thread the conduit nut onto the black threaded nipple on the weather dome with the
teeth on the nut away from the dome.
5. Wrap Teflon tape (installer supplied) around the black threaded nipple on the
weather dome.
6. Attach the safety cable from the building structure to the weather dome. Use a
looping sleeve, (part number 849511-0057) (not supplied) to secure the safety cable.
Route the safety cable through one side of the looping sleeve, around the pin in the
weather dome, and through the other side of the looping sleeve. Secure the safety
cable by crimping the looping sleeve. (See
Rev. 1.02
Section 3 for wiring information.
Section 3.2 for standard wiring.
Section 3.3 for Unshielded Twisted Pair (UTP) wiring.
15
Figure 9).
900.0696
1-Aug-06