Figure 5: Installing Conduit Fitting In Housing - Honeywell HD6 Series Installation Manual

2.4 HD6 RUGGED DOME HOUSING , CONTINUED
4. Locate the housing and set the jumpers and switches as applicable on the circuit
board.
Refer to
Refer to
Refer to
5. After completing wiring, continue basic installation for HD6 Rugged Dome housing.
6. Install a ¾" conduit fitting (not supplied) in the hole on the housing. Place the
supplied washer between the hole in the housing and the conduit fitting to prevent
leakage. Tighten the conduit nut to secure the fitting to housing and prevent
leakage.
Conduit Fitting
Washer
Rev. 1.02
Section 3 for wiring information.
Section 3.2 for standard wiring.
Section 3.3 for Unshielded Twisted Pair (UTP) wiring.
Conduit Nut

Figure 5: Installing Conduit Fitting In Housing

11
Housing
900.0696
1-Aug-06