Factory Reset - Roberts WM201 Owner's Manual

Factory reset

If you wish to completely reset your radio to its initial state this may be
performed by following this procedure.
1. Use the Select control to switch on your radio and to access the
menus. If needed, use the Back option to access the main Mode
menu. Rotate the Select control until 'Configure' is highlighted on
the display.
2. Press the Select control to enter the Configure menu. Rotate the
Select control until 'Factory Reset' is highlighted on the display.
3. Press the Select control again and the display will show 'Are you
sure?'. Rotate the Select control to highlight 'Yes' if you wish to carry
out a system reset or highlight 'No' if wish to return to the previous
screen. Then press the Select control again.
4. A full reset will be performed, the station list together with any preset
stations will be erased and your wireless network connection details
will be lost. All configuration settings will be restored to their defaults,
and the language used for menus will be reset to English.
In the event that you are unable to access the menus (or if the language
setting has accidentally been changed to a language that you cannot
understand) the Factory Reset may also be performed as follows:
1. Remove all power from the unit and wait 30 seconds.
2. Then, re-apply power while simultaneously pressing and holding the
front panel rotary control. Keep this pressed as the radio powers up
and until it displays 'Factory Reset Complete'. This should normally
only take between 10 and 15 few seconds. Then, release the control
while the radio restarts.
3. If this is not successful, please remove power for one minute, and
then repeat the operation.
55
Radio Stations
Media Player
Auxiliary input
Alarm clock
1-3
Upgrade Firmware
Factory Reset
Are you sure?
Factory Reset
2
Configure
Off
Register
Version
<<Back
YES NO
Complete