Batteries - Roberts Analogue World Radio R9968 User Manual

Batteries

1. Batteries should be replaced when the Battery Level icon
shows low.
2. Press the On/Off Sleep button to switch the radio off before
replacing the batteries.
3. Open the battery cover located on the underside of your receiver
by pressing down and lifting the battery cover.
4. Insert 2 x AA batteries into the compartment. Make sure that the (+)
and (-) ends of the batteries are positioned as shown on the rear
of the receiver.
Note: 2 beep sounds will be heard to signify correct battery insertion.
5. Close the battery cover.
6. Press the On/Off Sleep button to switch the receiver on after the
batteries have been replaced.
7. If the receiver is not to be used for an extended period of time it is
recommended that the batteries are removed from the receiver.
8. When the power is too low for the receiver to operate the Battery
Level icon will flash and the unit will shut down automatically.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
2
6
7