Contents Controls ... 2-3 Batteries ... 4 Operating your radio - FM ... 5 Operating your radio - Medium and Long wave ... 6 Operating your radio - Shortwave ... 7 Headphones ... 8 Mains adaptor ... 8 Specifications ... 9 Guarantee ...
Controls (front) If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 1. Telescopic aerial 2. SW band switch 3. Waveband switch 4. Tuning indicator 5. Tuning scale...
Page 4
Controls (left and right hand ends) 6. Volume control 7. Headphone socket 8. DC input socket 9. Tuning control 10. On/Off switch 11. Battery compartment...
Batteries 1. Remove the Battery cover on the rear of your radio by pushing the battery door in and down- wards. 2. Insert two LR6 (AA size) batteries into the spaces in the compartment. Take care to ensure all batteries are inserted with the cor- rect polarity as shown on the rear of your radio.
Operating your radio - FM 1. Switch on your radio by sliding the Power On/Off switch to the On position. 2. Slide the Waveband selector switch to the FM position. 3. Adjust the Volume control until a hissing sound is heard. 4.
Operating your radio - Medium and Long wave 1. Switch on your radio by sliding the Power On/ Off switch to the On position. 2. Slide the Waveband selector switch to the MW or LW position. 3. Adjust the Volume control until a hissing sound is heard.
Operating your radio - Shortwave 1. Switch on your radio by sliding the Power On/ Off switch to the On position. 2. Slide the Waveband selector switch to the SW position. 3. Select the required SW band using the SW band selector switch.
Mains adaptor (not included) The AC adaptor for use with the R9962 should provide 3 volts DC output at 200mA centre pin negative. Plug the lead from the adaptor into the DC socket located on the left hand end of your radio.
Specifications Power Requirements Batteries : 3V 2 x LR6 (AA) size External : 3V 200mA (centre pin negative) Battery Life Approx. 20hrs of listening for 4 hours a day at normal volume, using Alkaline cells. Loudspeaker 50mm 8 ohm. Output Power 120mW into 4 ohms.
In the event that it is not possible to return the instrument to the Roberts’ dealer from whom it was purchased, please contact Roberts Radio Technical Services department at the address shown on the rear of this manual before taking further action.
Page 12
ROBERTS RADIO TECHNICAL SERVICES DEPARTMENT 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 020 8758 0338 (Mon-Fri) Issue 3 Website: http://www.robertsradio.co.uk...