HPE FlexNetwork HSR6800 Configuration Manual page 30

Step
9. Configure a MAD IP
address for a member on
the VLAN interface.
Configuring ARP MAD
When you configure ARP MAD, follow these guidelines:
•
If an intermediate device is used, you can use common data links as ARP MAD links. If no
intermediate device is used, set up dedicated ARP MAD links between IRF member devices.
•
Use a VLAN dedicated to ARP MAD.
•
If an intermediate device is used, make sure the following requirements are met:
Run the spanning tree feature between the IRF fabric and the intermediate device.
Enable the IRF fabric to change its bridge MAC address as soon as the master leaves.
Create an ARP MAD VLAN and assign the ports on the ARP MAD links to the VLAN.
If the intermediate device is in an IRF fabric, assign this fabric a different domain ID than the
ARP MAD-enabled fabric to avoid false detection of IRF split.
To configure ARP MAD:
Step
1. Enter system view.
2. Assign a domain ID to the
IRF fabric.
3. Create a VLAN dedicated to
ARP MAD.
4. Return to system view.
5. Enter Ethernet interface
view or interface range
view.
Command
mad ip address ip-address { mask |
mask-length } member member-id
Command
system-view
irf domain domain-id
vlan vlan-id
quit
•
Enter interface range view:
Method 1:
interface range
{ interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5>
Method 2:
interface range name
name [ interface
{ interface-type
interface-number [ to
interface-type
interface-number ] }
&<1-5> ]
•
Enter Ethernet interface view:
interface interface-type
interface-number
26
Remarks
By default, no MAD IP address
is configured on any VLAN
interface.
Repeat this step to assign a
MAD IP address to each
member device on the VLAN
interface.
Remarks
N/A
The default IRF domain ID is 0.
The default VLAN on the device
is VLAN 1.
N/A
To assign a range of ports to
the BFD MAD VLAN, enter
interface range view.
To assign one port to the BFD
MAD VLAN, enter Ethernet
interface view.