Configuration Procedure - HPE FlexNetwork HSR6800 Configuration Manual

Irf configuration guide
Hide thumbs Also See for FlexNetwork HSR6800:
Table of Contents

Advertisement

Figure 16 Network diagram

Configuration procedure

1.
Configure Router A:
# Assign member ID 1 to Router A and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port2] quit
# Save the configuration.
[Sysname] quit
<Sysname> save
# Enable IRF mode.
<Sysname> system-view
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup.
Continue? [Y/N]:y
Do you want to convert the content of the next startup configuration file
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Router A reboots to form a one-chassis IRF fabric.
2.
Configure Router B:
# Assign member ID 2 to Router B and bind Ten-GigabitEthernet 3/0/1 to IRF-port 1.
<Sysname> system-view
[Sysname] irf member 2
35

Advertisement

Table of Contents
loading

Table of Contents