HPE FlexNetwork HSR6800 Configuration Manual page 28

Step
4. Configure the aggregation
group to operate in dynamic
aggregation mode.
5. Enable LACP MAD.
6. Return to system view.
7. Enter Ethernet interface
view or interface range
view.
8. Assign the Ethernet port or
the range of Ethernet ports
to the specified aggregation
group.
Configuring BFD MAD
When you configure BFD MAD, follow these guidelines:
Category
BFD MAD VLAN
BFD MAD VLAN and
feature compatibility
Command
link-aggregation mode dynamic
mad enable
quit
•
Enter interface range view:
Method 1:
interface range
{ interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5>
Method 2:
interface range name
name [ interface
{ interface-type
interface-number [ to
interface-type
interface-number ] }
&<1-5> ]
•
Enter Ethernet interface view:
interface interface-type
interface-number
port link-aggregation group
number
Restrictions and guidelines
•
Do not enable BFD MAD on VLAN-interface 1.
•
If an intermediate device is used, assign the ports of BFD MAD links to
the BFD MAD VLAN on the device.
•
The IRF fabrics in a network must use different BFD MAD VLANs.
•
Do not use the BFD MAD VLAN for any purpose other than configuring
BFD MAD. Layer 2 or Layer 3 features, including ARP and LACP, cannot
work on the BFD MAD-enabled VLAN interface or any port in the VLAN.
If you configure any other feature on the VLAN, neither the configured
feature nor the BFD MAD function can work correctly.
•
Disable the spanning tree feature on any port in the BFD MAD VLAN.
The MAD function is mutually exclusive with the spanning tree feature.
•
Do not bind a BFD MAD-enabled VLAN interface to any VPN instance.
The MAD function is mutually exclusive with VPN.
24
Remarks
By default, an aggregation
group operates in static
aggregation mode.
Perform this step also on the
intermediate device.
By default, LACP MAD is
disabled.
N/A
To assign a range of ports to
the aggregation group, enter
interface range view.
To assign one port to the
aggregation group, enter
Ethernet interface view.
Multichassis link aggregation is
allowed.
Perform this step on the
intermediate device as well.