Table of Contents
Advertisement
Installing and removing an accessible drive
Push the new power supply module into the server (1) and secure it with the
Ê
two quarter-turn fasteners (2).
If you remove a power supply module without replacing it, you must refit
!
the bay cover.
Installing and removing an accessible drive
The server accommodates up to five accessible drives (four 5 1/4-inch drives and
one 3 1/2-inch drive). A 5 1/4-inch drive carrier can house two half-height drives or
one full-height drive.
For each accessible SCSI drive that you install you must assign a unique SCSI ID
(0 - 6) and remove or disable the terminating resistor. As the CD-ROM drive
already fitted is located at the end of the SCSI cable, a terminating resistor is
connected and enabled.
Ê
Read the documentation supplied with the drive and make the required
settings (SCSI ID, resistors) at the drive.
A26361-K412-Z107-3-7619
2
1
2
System expansions
59
Advertisement
Table of Contents
