Transmitter Data Ar620X And Rt6201; Emergency Operation - Becker AR6201 Installation & Operation Manual

Rated output for speaker operation .. ≥ 4 W into 4 Ohm
Rated output power for headphone 1 .. ≥ 300 mW into 75 Ohm
Rated output power for headphone 2 .. ≥ 200 mW into 75 Ohm
Audio auxiliary input ............... 50 mV to 8 V (adjustable) across 600 Ohm
Offset-carrier operation ........... YES (25 / 8.33 kHz)
1.7.5

Transmitter Data AR620X and RT6201

Output power into 50 Ohm ....... ≥ 6 W for AR620X-(X2X) and RT6201-(X2X)
(with and without modulation): . ≥ 10 W for AR620X-(X1X) and RT6201-(X1X)
Frequency tolerance ............. ≤ ±5 ppm
Duty cycle ...................... 120 sec (TX): 480 sec (RX)
Type of modulation .............. A3E
Modulation capability ........... ≥ 70%
Distortion ...................... ≤ 15%
Audio frequency response ........ ≤ 6 dB, 350 Hz to 2500 Hz
(8.33 kHz channel spacing)
Audio frequency response ........ ≤ 6 dB, 300 Hz to 2500 Hz
(25 kHz channel spacing)
Dynamic microphone .............. 1...20 mV compressor starting point,
(with compressor)
Standard microphone(s) .......... 10...1000
(with compressor)
FM deviation with modulation .... ≤ 3 kHz
Sidetone ........................ Adjustable
Automatic shutdown of transmit mode 120 sec.
(Factory configurable 30 sec ... 120 sec)
1.7.6

Emergency Operation

If the device enters emergency operation, the speaker is switched "OFF"
due to degraded performance. Depending on settings in installation setup
"LOW BATT" may be indicated if supply voltage drops below a predefined
threshold to indicate to the user, that he should connect his headset as
the speaker may be switched "OFF" soon).In this case, a headset is
Page 1-12
AR6201 - RT6201 - RCU6201 - AR6203
adjustable
Input balanced, 200 Ω
Input range up to 20 dB above compressor
starting point.
adjustable
Input unbalanced, 150Ω
Input range up to 20 dB above compressor
starting point.
≥ 100 mW into 600 Ohm
≥ 100 mW into 600 Ohm
mV compressor
DV 14307.03 Issue 1 09/2013
starting point,