Changing Presser Foot; Threading Upper Thread - Bernina Favorit 940 Instruction Book

Changing Threading Bringing out
U
Presser Foot Upper Thread Lower Thread
a
The success or other- * Check whether needle * Hold end of upper
*
Tighten upper and
wise of a piece of
is up. thread loosely. lower threads slightly
U
sewing largely depends * Raise presser foot.
* Turn hand-wheel once and place visibly under
on the correct choice of * Place reel of thread on towards you until the
the presser foot (Fig. 6).
presser foot. It must one of the two reel thread take-up lever is
therefore be simple and holder pins. Hold reel of
up.
quick to change the thread firmly while * By pulling thread
presser foot.
threading (Fig. 4). slightly the lower thread
(See page 9 concerning
is drawn out through the
U
presser feet and their
needle plate hole.
range of application).
U
* Check whether needle
is up. Raise presser foot
l
(Fig 1).
4
kI-flNINA
3
* Raise clamping lever ld
*
First suspend the
with the index finger of
thread in the thread
the right hand and guide at the rear of the
remove the presser foot machine, then place in
using the middle finger the slot of the take-up
and thumb) (Fig. 2).
lever at the top and then
again downwards to the
U
needle holder thread
guide (Fig. 5).
* Always thread needle
from front. The small
* Securing the presser
>1-
X
white plate at the front
foot: same procedure,
of the presser foot shaft
U
but press clamping lever
.
makes it easier to thread
downwards with index h _ the eye of the needle.
U
finger (Fig. 3).
6=
i i i
AS t - ... .......... S,,9
\t
AM
,, ,N,,, ,,p,A,,
ffl ,9 EE,,,
Z_.-_...M
6-----