Panasonic AV-HLC100E Operating Instructions Manual page 107

Begin by telling Skype TX Control to connect to
•
your AV-HLC100.
Do this by entering the entering the target
system's IP address into the "Add a Skype TX
unit to control" into the Configuration panel of
the Control application.
A new column will be shown at left in the main
•
panel of the Control application, asking you if
you want to add a channel to control.
• Select the channel shown, and you will be
asked to enter credentials to access that
system.
Note: Your AV-HLC100 must be set to
require a password to work with Skype TX.
After this, the Control application connects to
•
the available Skype TX channel from AV-
HLC100, and is ready to accept Skype traffic.
Notes: Much more information on using Skype TX
Control is available at this URL:
https://media.skype.com/skype-tx/
(Although configuring SkypeTX Control takes a little
time, and can be a little intimidating at first, it's easy to
use once you learn how – and only needs to be done
once.)
FIGURE 107
FIGURE 108
107