Stand-by alarm setting mode 1
Set a ratio (for the rated current) of current used for threshold value to judge stand-by power
using <ITEM/△>, <SHIFT/▽>, < >, < >.
Stand-by alarm setting mode 2
Set a time used for threshold value to judge stand-by power using <ITEM/△>, <SHIFT/▽>, < >, < >.
* "0": Alarm is always output at the time when judging the stand-by power.
* "1 to 9999": Alarm is output at the time when passing the setting time with the stand-by power.
The alarm can be reset by pressing <SET> with display of instantaneous electric power, current,
voltage,frequency and PF. After reset the alarm, start to monitor the stand-by power again.
Preset value setting mode
Display changes to set an alarm value after "Cnt" is displayed at the upper line for 1 sec.
Set preset value to output using <ITEM/△>, <SHIFT/▽>, < >, < >
After
1sec.
When prescale value is an
*It is only when "AL-S" is selected on unit for pulse output setting mode.
↓<SET>
*It is only when "AL-S" is selected on unit for pulse output setting mode.
( 0 to 9999 minutes)
↓<SET>
*It is only when "Cnt" is selected on unit for pulse output setting mode.
( 0 x Prescale value to
99 999999 x Prescale value)
integer.
↓<SET>
KW8M Eco-POWER METER (1A/5ACT input type)
ITEM
(1.0 to 100.0)
△
SHIFT
▽
ITEM
△
SHIFT
▽
ITEM
Increase value
△
SHIFT
Decrease value
▽
Shift place to set
Shift place to set
Over 9 digits, it shifts to the upper digit.
When prescale value is to two
places of decimals.
19
Increase value
Decrease value
Shift place to set
Shift place to set
Increase value
Decrease value
Shift place to set
Shift place to set
When prescale value is to three
places of decimals.