Panasonic KW8M User Manual page 24

Mode1 Setting flow chart
Phase/Wire system setting mode
Press <ITEM/△>, <SHIFT/▽> to change Single-phase 2-wire ⇔ Single-phase 3-wire ⇔
1P2W
CT type setting mode
Press <ITEM/△>, <SHIFT/▽> to change 1 ⇔ 5 .
Primary side current of CT setting mode
Set primary side current of CT using <ITEM/△>, <SHIFT/▽>, < >, < >.
If measured CT is 100A/5A, set to 100. If 5A is measured, set to 5.
Voltage range setting mode
Press <ITEM/△>, <SHIFT/▽> to change 400V ⇔ 200V.
Monitor
↓ <MODE>
MODE1 display
↓<SET>
1P3W
↓<SET>
1
↓<SET>
*It is only when "5A" is selected on CT type setting mode.
(1～4000, Initial 5)
↓<SET>
400V
↓<SET>
16
KW8M Eco-POWER METER (1A/5ACT input type)
Three-phase 3-wire ⇔ Three-phase 4-wire.
3P3W
5
ITEM
Increase value
△
SHIFT
Decrease value
▽
Shift place to set
Shift place to set
200V
3P4W