RIDGID TS3660 Operator's Manual page 21

ASSEMBLY
To assemble the Herc-U-Lift™ to the leg stand:
 Install the four leg brackets on the inside of each leg using
head screws (1/4-20 x 1/2 in.) and lock nuts (1/4-20).
Tighten securely.
 Place the lower section under the leg stand with the ends
of the tube under the front leg brackets. Place a screw
with washer (1/4-20 x 1-5/8) through the leg bracket and
the end of the tube of the lower section. Secure in place
using lock nuts (1/4-20).
NOTE: The screw should freely pivot.
 Repeat above step for the upper section of the Herc-U-
Lift™.
 Check to insure the upper and lower sections are centered.
If required, loosen frame hardware and adjust the frames
side to side to center. Retighten all hardware.
 Press down on the unlock pedal to check alignment of
the U-bolt. The U-bolt should be centered within the latch
mechanism as shown in figure 16. Release the unlock
pedal and adjust the U-bolt as necessary. Retighten all
hardware.
NOTE: With the tool on a level surface, check to make sure
the tool does not move. If tool moves, adjust all four leveling
feet supporting the tool.
TO INSTALL BEVEL ADJUSTING HAND-
WHEEL
See Figure 17.
 Locate the following parts:
1 bevel handwheel
1 pan head screw (1/4-20 x 5/8 in. with washer)
 Push bevel handwheel onto the bevel shaft aligning
flats on the bevel shaft with the flats on the bevel
handwheel.
 Secure in place using the screw (1/4-20 x 5/8 in. with
washer).
TO INSTALL HEIGHT ADJUSTING HAND-
WHEEL
See Figure 18.
 Remove blade height lock knob by turning the knob
counterclockwise.
 Slide the height adjusting handwheel onto the rod and
against the lock tube.
 Secure the height adjustment handwheel by reinstalling
the blade height lock knob.
UNLOCK
PEDAL
LATCH
MECHANISM
CENTER U-BOLT WITHIN THE LATCH MECHANISM
LOCK
BLADE
TUBE
HEIGHT
LOCK KNOB
HEIGHT
ADJUSTING
HANDWHEEL
21
U-BOLT
ADJUSTING
HANDWHEEL
PAN HEAD
(1/4-20 x 5/8 in.)
Fig. 16
BEVEL
SCREW
Fig. 17
Fig. 18