RIDGID TS3660 Operator's Manual page 22

ASSEMBLY
TO STORE ACCESSORIES
See Figure 19.
The table saw has two convenient storage areas (one on
either side of the saw cabinet) specifically designed for the
saw's accessories.
When not in use, store the accessories securely by snapping
each accessory in place.
TO INSTALL FRONT AND BACK RAILS
See Figures 20 - 22.
To Install Front Rail:
 Insert square head bolts (5/16-18 x 1 in.) into the holes
on the front of the saw table and extension tables.
 Attach flanged hex nut (5/16-18) loosely allowing the
square bolt head to protrude.
 Slide the front rail slot over each of the square head bolts
and finger tighten the nuts.
 Align the front rail with the 7-1/8 in. mark on the right side
rip scale with the right edge of the cast iron table top.
To Install Back Rail:
 Insert square head bolts (5/16-18 x 1 in.) into the holes
on the back of the saw table and extension tables.
 Attach flanged hex nut (5/16-18) loosely allowing the
square bolt head to protrude.
 Slide the back rail slot over each of the square head bolts
and finger tighten the four nuts.
 Place a framing square on either side of the blade. Move
the back rail right or left until the indicator mark is aligned
with the framing square. Finger tighten the nuts.
TOOL STORAGE
FRONT
RAIL
SQUARE HEAD
BOLT
(5/16-18 x 1 in.)
FLANGED
HEX NUT
(5/16-18)
RIGHT EDGE OF
TABLE TOP
Fig. 19
22
SQUARE
HEAD
BOLT
FLANGED
HEX NUT
(5/16-18)
Fig. 20
REAR
EXTENSION
RAIL
Fig. 21
Fig. 22